(Optional) Wash With Warm Water.

White vinegar solution is acidic, so it may cause discolouration on a dark carpet.Remember to test a small area with the solution (and let it fully dry) before you remove stains.. For this method, you’ll need to mix a small amount of distilled white vinegar with warm water in a spray bottle.

dilution ratio should be around 1:20. , which is approximately one teaspoon of vinegar for every 100ml of water..Begin by using a damp cloth to dab up as much of the stain as possible.Don’t rub the stain though, as this can damage the fibres and force the stain deeper into the carpet.. Then, using a new cloth, dab the entire area with the vinegar solution before leaving it for around 10 minutes.. Next, rinse the area with a clean cloth using cold water, then blot up the liquid with a microfiber cleaning cloth.

You may need to repeat this sequence multiple times to remove the entire stain.. Continue blotting until all excess moisture is removed, then allow the carpet time to air dry..Tip: Make sure you don’t oversaturate your carpet during the cleaning process.

It should be damp rather than wet.. 3.

Washing Up Liquid And Vinegar.They may take longer in humid or cold environments though, so double-check that the filter is completely dry before moving to the next step..

In the CH950UKT manual, Shark specifically mentions that you shouldn’t use a hair dryer (or any other drying tool) to speed up the process.The filters should only be air-dried..

Step 5: Re-Assemble The CH950UKT.Once the filters are dry, you can put them back into the filter frame.